Lone Worker Monitoring

Mode 1 - Manual alarms only:

The top side button will send an "ASSIST" lone worker message to the pager together with slow audible beep. The lower side button sends a "CANCEL" lone worker message to the pager together with a double audible beep. Pressing both buttons together and holding them for the trigger period will send an "ALARM" lone worker message to the pager together with a triple audible beep.

Mode 2 - Manual alarms and active detachable pin:

The pin in the base of the unit is for connection to a lanyard attached to the wearer. If the transmitter is pulled away from the wearer, an automatic transmission is initiated that sends a "DURESS" lone worker message to the pager together with a rapid audible beep. These transmissions will be repeated every 3 seconds until the pin is replaced. This could for example, be clipped onto the structure where the lone worker is working at a height - should a fall or accident occur the lanyard will automatically detach and active the system.

Mode 3 - All alarms active:

This mode enables all functions, manual alarms, captive pin and movement detector. The movement detector has two time periods over which any movement detected will reset the timers. If the unit detects no movement for 20 seconds it will pulse a sounder for 10 seconds as a warning before transmitting a "DURESS" 'man down' message. Any movement detected during these warning periods will reset the timers.

Receivers

Display Pager

The Display Pager lone worker receiver allows for a stand alone one-to-one solution that will alert a colleague to an alarm or duress situation. The pager is a simple and discrete unit which can be 'belt worn' or carried in a pocket and allows complete flexibility for co-worker protection in a lone worker environment. The unit is capable of both tone and vibrate alert.

Another advantage of the pager receiver is that, as it is portable, it can be moved from location to location and lodged with a responsible minder, receptionist etc. at any given site.

Display Pager Kit

The Display Pager Kit consists of:

The Guardian Lone Worker Transmitter c/w desk top charger and mains power supply; belt carry case; display pager with holster clip and bungee cord; single AAA alkaline battery for pager.

Non-supervised Fixed Lone Worker Receiver

The Non-supervised Fixed Lone Worker Receiver utilises a 12 volt DC powered receiver unit for connection to a suitable existing power source. The unit has four programmable output relays for connection to an external alarm or signalling device. Pagers can also be utilised to operate in conjunction with the fixed receiver.

Non-supervised Fixed Lone Worker Receiver Kit

The Non-supervised Fixed Lone Worker Receiver kit consists of:

The Guardian lone worker transmitter c/w desk top charger and mains power supply; belt carry case; 12 volt DC wall mounted non-supervised receiver in ABS enclosure; stub quarter wave aerial.

To view our related Personal product as a PDF please click The Westminster Guardian.

To view our related Personal Emergency locating product as a PDF please click Personal Emergency Locating System.

To view our related Personal Alarm System product as a PDF please click Personal Alarm System.

For more information - please click here to contact us.